How much space do you need for a 2 post lift?
The basic rule is that you need the pads to be 12″ wider on each side from the base plates of the lift. For a 2 post, you’ll need to go down at least 2 feet. For a 4 post, you’ll need to go down at least 6 inches.
How wide is a 2 post ramp?
Lifting height: 1900 mm. Minimum height: 100 mm. Overall height: 2824 mm. Overall width: 3380 mm.
What is the width of a car lift?
BendPak’s HD-7W is the standard-width car lift model in the HD-7 series. With a 110.25” overall width and a spacious 100.25” spread between the columns, there’s plenty of room to park most cars and trucks in the lower position. This leaves ample space for you to maneuver.
How thick of concrete do you need for a 2 post lift?
4 inches
Here are our tips for making sure your installation is an uplifting experience. Some of manufacturers standards for a 2-Post and 4-Post Lifts require a minimum 4 inches of reinforced concrete slab to be safely installed.
How tall is a 2 post car lift?
The total column height of 111 ½” (9 feet 3 ½ inches) allows this lift to be installed in almost any professional or home garage with a ceiling as low as 9 feet 6 inches.
Can you store a car on a 2-post lift?
First things first: never, ever park a vehicle under a two-post lift. Sorry if we come off a bit harsh, we just have no tolerance for unsafe decision-making and can never support using a two-post lift like it’s a parking lift. Even if it’s a fully certified BendPak, our own brand.
How thick should a slab be for a car lift?
For a proper lift installation, begin by evaluating your concrete area and its existing specifications. This begins by inspecting your concrete slab to make sure it’s an adequate 4.25” thickness or more, has cured at least 28 days, and the surface has no more than a 3-degree slope.
Where should I position my two post lift?
Raise the lift about 12” off the floor and locate the bleeder screw on top of either cylinder.
What is the best 2 post car lift?
– MaxJax lift is efficient and convenient, easily portable, yet strong enough, offering the best of both worlds. – It is easy to install and use, which you can do all alone, especially for DIYers. – This lift provides an upgrade over the regular jack stands when coupled with its creation of ample working space.
How to install a 9000 lb 2 post lift?
You can still install a car Lift by modifying the slab in a couple of ways. In this case you can cut out a 4 feet x 4feet square form the old slab, and pour new concrete to a depth of about 10 to 12 inches (approx 1 foot deep). You can then tie this new section of slab back into the existing slab with re-bar drilled in.
How to use a two post lift?
– Stronger – Hydraulic system – 10,000 LB heavy duty – CE certified lift structure – Strong double “S” column design