What does E1 mean on a Smeg dishwasher?
Overfill detected This will abort
3 Button with LCD Display Dishwashers
Error Code | Explanation |
---|---|
E1 | Overfill detected This will abort the current program |
E2 | Water level. This will abort the current program |
E3 | Not heating. This will abort the current program |
E4 | Temperature probe of thermostat failure |
How do I fix E1 error on my dishwasher?
- Ensure Drain Hose is Installed Properly. Improperly installed drain hoses are a common defect with a lot of dishwasher installations.
- Use the Proper Detergents.
- Make Sure Your Door Isn’t Leaking.
- Make Sure You’re Loading Dishes Properly.
How do you reset Smeg dishwasher?
How to Reset a Smeg Dishwasher
- Open the dishwasher door and quickly close it.
- Locate the “On/Off” button on the left side of the dishwasher control panel.
- Select and run a dishwashing cycle to ensure that the dishwasher control board has been reset successfully.
Why is my Smeg dishwasher flashing?
The light flashes to indicate that the appliance is in “water hardness adjustment” mode. SALT WARNIN LIGHT (on some models only) If the symbol is present, illumination of this light denotes a regenerating salt warning level.
What does E01 mean on a dishwasher?
What Does the E01 Code Mean? This code indicates that there is a problem with the rinse cycle that is supposed to take place once the wash cycle is complete. If the water inside your dishwasher is not properly restored, this error will appear. In other words, not enough water is entering the appliance.
What does the E stand for in E1?
E1 means “Everyone.”
Can you reset a dishwasher?
Can you reset your dishwasher? Yes, you can reset your dishwasher by pressing the Start/Reset button on the appliance and waiting a few minutes. If your dishwasher still doesn’t start, you may need to reboot the entire system by turning off power to the appliance at the house circuit breaker or fuse box.
What is wrong with my Smeg dishwasher?
A Smeg dishwasher not starting could simply be a problem with the power supply – the appliance won’t start if water is unable to be drawn from the mains water supply. And then the dishwasher should verify the setup and start of a wash cycle. If this isn’t happening the power outlet itself may be at fault.
Which Smeg dishwasher do I have?
The Smeg model number is located on the lower part of the Smeg hob which is fixed to the casing. In order to read it, you must access the lower part. A copy of the label is included with the instruction booklet.
What does 1 mean on Bosch dishwasher?
Error code 1 indicates a water sensor or filling error.
What is the capacity of 1 E1?
E1 is the European variant of T1. It was defined by the European Conference of Postal and Telecommunications Administrations and provides for a link speed of 2.048 Mbps. This enables each user channel to have 64 Kbps of usable bandwidth. E1 links can simultaneously carry 32 voice calls.