How do you clear the error code on a GE washing machine?
To clear and verify a GE washing machine error:
- Press and hold the “Power” button until the error clears.
- Unplug the washing machine from its power source.
- Wait at least three minutes.
- Plug the washing machine back into the power.
- Allow the washer to reboot.
- Attempt to run a wash cycle.
How do I check the error code on my GE front load washer?
To enter this test mode, press start/pause and to exit press power. To enter the error code test mode on a GE front load washer, rotate the control knob until t02 is displayed in the control panel then press start/pause to enter the test mode. This is where all error codes are stored.
How do I stop the LED lights from flashing on my GE stackable washer and dryer?
61 second suggested clip3:244:38GE stackable washer/dryer lights blinking – YouTubeYouTubeStart of suggested clipEnd of suggested clipAnd this can all be seen in the service tech sheet we’re going to hold start and fabric again forMoreAnd this can all be seen in the service tech sheet we’re going to hold start and fabric again for three seconds and move to position six to get out of it.
How do you reset a GE washer and dryer?
Motor Reset Procedure:
- Unplug the washer for 1 minute from the electrical outlet.
- Plug the washer back in and lift and lower the lid 6 times within a 12 second period. You have 30 seconds to start lifting and lowering the lid.
- The motor has now been reset and is ready for you to start a cycle.
How do you run a diagnostic on a GE dryer?
61 second suggested clip0:125:49GE Test Modes – YouTubeYouTube
How do I find my GE error code?
57 second suggested clip1:266:05How to Find Error Codes, and Reset a GE Washer – YouTubeYouTube
How do I put my GE dryer in diagnostic mode?
56 second suggested clip0:055:49GE Test Modes – YouTubeYouTube
What does dE mean on GE washer?
A dE error code indicates that the washer door was unable to lock. This can normally be resolved by performing a simple reset on the washing machine.
Why are the lights flashing on my GE washer?
What is this? Even though the washer is spinning, you might still see a flashing light. This is an out-of-balance signal, meaning that the washer struggles to balance the load and spin at full speed.
Why is my GE washer fill light blinking?
If the Fill light is flashing or H2O SUPPLY is scrolling on the display (2015 and newer models), the washer will initiate a 3 or 4 minute lock-out period (depending on the model). The washer controls won’t respond or change during this time. After 3 or 4 minutes, you can choose your settings and press Start.
Is there a reset button on GE dryers?
The most obvious option is the reset button. You can find it on the control panel or the front of the plug. Press it to reset the GE dryer. You can also reset the dryer by turning it off and disconnecting the appliance from its power source.
Is there a reset button on GE washers?
To reset the electronic controls on your washer, shut off the circuit breaker or fuse to the washer or unplug the washer for 2 minutes. For models that have a timer control knob, turn the knob around and back to any position other than final spin for the interrupted cycle. Then, restore power.