How do I enable mSATA in BIOS?
To Set the System BIOS and Configure Your Disks for Intel SATA or RAID
- Power on the system.
- Press the F2 key at the Sun logo screen to enter the BIOS Setup menu.
- In the BIOS Utility dialog, select Advanced -> IDE Configuration.
- In the IDE Configuration menu, select Configure SATA as and press Enter.
Can I install Windows on mSATA?
You can install and run an operating system on an mSATA ssd. However, you would have to be able to access the motherboard’s system BIOS. Once you have access you would have to disable Intel Smart Response to eliminate the ssd cache; select the mSATA ssd as the primary boot device; and make sure ACHI mode is enabled.
How do I make my Dell SSD a boot drive?
Workaround
- Enter the BIOS by pressing F2 multiple times while the Dell Logo is shown.
- Go to Boot Sequence and set Boot List Option to UEFI.
- Go to SATA Operation and choose AHCI.
- In Advanced Boot Option, you click Enable Legacy Option ROMs.
- Set Secure Boot to Disable.
Why is my hard drive not detected in BIOS?
The BIOS will not detect a hard disk if the data cable is damaged or the connection is incorrect. Serial ATA cables, in particular, can sometimes fall out of their connection. Be sure to check your SATA cables are tightly connected to the SATA port connection.
How do I know if my Dell hard drive is detected in BIOS?
During startup, hold F2 to enter the BIOS Setup screen. Check whether your hard drive is listed under Bootable Device. If your hard drive isn’t listed, this indicates that there are no bootable system files on the hard drive.
How do I boot from SSD without HDD?
Here are the steps to make SSD the boot drive on windows 11/10:
- Restart PC and press F2/F12/Del keys to enter BIOS.
- Go to the boot option, change the boot order, setting OS to boot from the new SSD.
- Save the changes, exit BIOS, and restart the PC. Wait patiently to let the computer boot up.
How do I make my SSD bootable?
How do I install SSD drivers in BIOS?
Solution 2: Configure the SSD settings in BIOS
- Restart your computer, and press the F2 key after the first screen.
- Press the Enter key to enter Config.
- Select Serial ATA and press Enter.
- Then you’ll see SATA Controller Mode Option.
- Save your changes and restart your computer to enter BIOS.