Can pinewood derby car be less than 7?
Can a pinewood derby car be shorter than 7 inches? Yes, you can make your car shorter but it is not recommended. A shorter car will have a lower center of mass at the start so it will have less energy to convert into speed when going down the track.
Can a pinewood derby car have 3 wheels?
Especially when using axle slots, it is often quite difficult to get all four wheels to touch the ground evenly. In fact, many times people end up with three-wheeled pinewood derby cars by accident! Don’t let your car design be accidental.
Can you move the wheels on a pinewood derby car?
ONLY the official Cub Scout Grand Prix Pinewood Derby wheels, axles and body are to be used. Wheels are not permitted to extend past the front or rear of the car body. C. Width – between wheels – will not be less than 1-3/4”.
What kind of wood is used for pinewood derby cars?
Pine – Any of a variety of soft, light-colored woods used for pinewood derby kits. Ponderosa Pine – A soft western pine. Sugar Pine – A soft, western pine noted for a sweet smell. White Pine – A soft eastern pine.
What is the weight requirement for a pinewood derby car?
5 ounces
All cars must pass the following inspection to qualify for the race: Width shall not exceed 2-3/4 inches. Length shall not exceed 7 inches. Weight shall not exceed 5 ounces.
How can I make my Pinewood Derby car faster?
5 Quick & Easy Tips For Improving Your Pinewood Derby Car’s Speed
- Put all of your weight in the back.
- Lube the car at the body/wheel friction point.
- Spend a fair amount of time on axle prep.
- Make sure your wheels are ready.
- Finally, once your wheels are mounted, check their alignment.
Do you glue pinewood derby axles?
7. Create Glue Holes: Glue the axles firmly in their holes to ensure that they stay perfectly placed, but make sure you don’t get glue on your wheels. 8. Add Weight: Remember to make your Pinewood Derby car as heavy as the rules allow.
Can you glue axles on pinewood derby car?
For pinewood derby cars, white glue works fine for gluing wood to wood (such as adding wood accessories) and for repairing chips or cracks in the wood. It can also be used for holding the axles in place.