Can I put a V8 in a Fiero?
Dropping a General Motors Small Block V8 into the rear of the Pontiac Fiero is a relatively easy and inexpensive way to transform the mid-engine sports car into a much more serious performance package. Unlike many used Fieros we see, this particular car’s interior has been very well maintained.
Will an ls4 fit in a Fiero?
The only trans that will fit an ls series as well as a 3500, is a stock Fiero style fwd trans, however the ls has to be an ls4. If its not an ls4 then you need an adapter plate.
How fast can a Fiero go?
Specifications
Model | Pontiac Fiero | Pontiac Fiero GT |
---|---|---|
Power | 92 hp | 140 hp |
Torque | 134 lbft | 170 lbft |
Weight | 1170 kg | 1265 kg |
Top speed | 103 mph* | 125 mph* |
How much horsepower does a 1986 Pontiac Fiero have?
Power
Inline 4 | |
---|---|
Power : | 92 HP (67.712 KW) @ 4400 RPM |
Torque : | 132 Ft-Lbs (179 NM) @ 2800 RPM |
Bore : | 4.0 in | 102 mm. |
Stroke : | 3.0 in | 76 mm. |
Is Pontiac Fiero a good car?
In general, the Fiero was overbuilt, so the chassis and engines could withstand a lot of abuse. The Fiero is typically considered unreliable, but it can last for a long time as long as you fix these issues. It will always be an American classic.
Is the Fiero a good car?
Is the Fiero a mid-engine?
The Pontiac Fiero is a mid-engine sports car that was built by American automobile manufacturer General Motors from 1983 until 1988 for the 1984 to 1988 model years. It was the first two-seater Pontiac since the 1926 to 1938 coupes, and the first mass-produced mid-engine sports car by an American manufacturer.
Can you put a 3800 engine in a 1988 Fiero?
, sitting atop a 3800 V6. to make this combination a reality. While the 3800 takes up more room than that went into many 1985-1988 Fieros, it’s still a pretty compact engine (and Fiero swappers manage to get V8s into these cars without too much difficulty, too).
Can I use a stock Trans flywheel on a 3800?
If you are using a stock Fiero Muncie 4-speed or Getrag 5-speed manual transmission with a 3800 Series 2 or 3 engine, you can use a stock manual trans flywheel from a 1996-02 Camaro or Firebird 3800 Series 2 engine.
Can a 3800 compressor be mated to a Fiero AC system?
MONEY ORDER OR CHECK BY MAIL. Features being able to use the 3800 compressor mated to the Fiero AC system. The hoses are not the same size, so new ends must be welded to the existing ends, and 2 new hoses are provided by me. Item Name: This is to replace that ugly black multi port cap for those that are looking for that clean install look.
What was the first 3800 swap you did?
The very first 3800 swap I did used a ’92 Series I 3800 SC from a wrecked Park Avenue Ultra. I also kept the PCM and wiring as well as PASS-KEY module and ignition key resistor value for future use. For this first swap I did not yet have the ability to reprogram the stock chip.